ASRock IMB-A180 manual Jumpers Setup

2.3 Jumpers Setup

The illustration shows how jumpers are setup. When the jumper cap is placed on the pins, the jumper is “Short”. If no jumper cap is placed on the pins, the jumper is “Open”. The illustration shows a 3-pin jumper whose pin1 and pin2 are “Short” when a jumper cap is placed on these 2 pins.

Clear CMOS Jumper

(3-pin CLRCMOS1)	Default Clear CMOS
(see p.8, No. 28)

CLRCMOS1 allows you to clear the data in CMOS. To clear and reset the system parameters to default setup, please turn off the computer and unplug the power cord from the power supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right after you update the BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must boot up the system first, and then shut it down before you do the clear-CMOS action. Please be noted that the password, date, time, user default profile, 1394 GUID and MAC address will be cleared only if the CMOS battery is removed.

Panel Backlight Power Jumper	1-2	: +5V
(3-pin BKT_PWR1)	2-3	: +12V
(see p.8, No. 2)
LVDS Power (VDDR Power)	1-2 : +3V
Jumper	2-3 : +5V
(3-pin PNL_PWR1)
(see p.8, No. 8)

14