Reference

Maintaining the system

Changing the remote control battery is the only regular maintenance that is required. You may also clean the system as needed.

To replace the remote control battery

Replace the remote control battery when it stops operating (normally every year or two), or its range seems reduced. Use only a Duracell, Eveready, Energizer, Maxell, Toshiba, or Shun Wo CR2032 3-volt lithium battery. Keep in mind that lighting and other room conditions, in addition to battery age, can affect the operating range of an infrared remote control.

To clean the system

Wipe the system using a soft dry cloth. You can also lightly vacuum the grille.

Do not use solvents, chemicals, or sprays.

Do not allow liquids to spill or objects to drop into any openings.

Specifications

Input Requirement

Main Connection iPod docking connector

 

Auxiliary connection - 1 / 8” (3.5mm) mini stereo jack

Power Rating

Total 10 Watts RMS

Satellite speakers

2 x 2.5 Watts (4 ohm)

 

30mm drivers

Subwoofer

1 x 5 Watts (8 ohm)

 

2.5” dedicated low frequency high excursion driver

Power Supply

External AC Adapter (100 - 240V)

Frequency response

60Hz - 20KHz

Dimensions

6.1” x 6.9” x 5.7” (width x height x depth)

 

155mm x 176mm x 145mm (width x height x depth)

Weight

28.9oz / 820g

Reference

Troubleshooting

Problem

Your iPod does not dock properly

No sound

No sound and your iPod is not charging

Your iPod does not respond to the i-Ballroom remote control buttons shown

No sound, or cacophony when using the FM function

Low sound

Your i-Ballroom system does not respond to its remote commands or to the + and volume buttons on the front of the system

What to do

Check whether there is any barrier in the iPod jack or not.

Check whether the direction of iPod jack pins are all the same or not.

Make sure the system is plugged in, your iPod is turned on, and a music track is selected and playing.

Press the PLAY / PAUSE button on the remote control.

Increase the volume setting for the system.

Remove your iPod from the dock, wait briefly, then reseat it. You may need to do this a few times.

Make sure the power cable is securely plugged into a functioning outlet and with the DC plug plugged firmly into the DC input jack.

Make sure your iPod is firmly seated in the dock.

Remove your iPod from the dock, wait briefly, then reseat it. You may need to do this a few times.

Try the remote from a different location. If it works there, strong lighting or other room conditions may be causing the problem.

Make sure nothing blocks the infrared (IR) signal path from the remote to your i-Ballroom system. wipe off the small red lens on the front send of the remote.

Check the remote control battery to make sure the + side is up.

Replace the remote control battery.

Check the antenna to make sure it has already been plugged into the matched jack.

Check the system to make sure the FM function has been turned on.

Check the system to see whether the volume is adjusted to the smallest status or not.

Check the audio source to see whether the output is too small or not.

Unplug the power cable for 1 minute, then plug it back in. This resets the system.

Contact ASTONE Customer Service about the problem.

10

www.astone.com.au

www.astone.com.au11

Page 7
Image 7
Astone Holdings Pty high quality speaker system Maintaining the system, To replace the remote control battery