
3.HARDWARE SETUP
6)USB DeviceSet these jumpers to +5V to allow wake up from the S1 sleep state (CPU stopped; RAM refreshed; system running in low power mode) using the connected USB devices. Set to +5VSB to allow wake up from S3 sleep state (no power to CPU; RAM in slow refresh; power supply in reduced power mode). The default setting for the three jumpers is
1.This feature requires an ATX power supply that can supply at least 2A on the +5VSB lead when these jumpers are set to +5VSB. Otherwise, the system does not power up.
2.The total current consumed must NOT exceed the power supply capability (+5VSB) whether under normal working conditions or in sleep mode.
| USB01_PWR |
| |
1 | 2 | 2 | 3 |
+5V | +5VSB | ||
(Default) |
|
| |
| USB23_PWR |
| |
2 | 2 | 3 | |
1 | |||
+5V | +5VSB | ||
(Default) |
|
| |
|
|
|
This motherboard supports ASUS™ C.O.P. CPU Thermal Overheating Protection: it automatically shuts down the system power before temperatures go enough to permanently damage the CPU. The jumper selects the type of CPU and coordinates its thermal sensory capability. It is advisable to maintain the default setting of
| THERMTRIP |
| |
1 | 2 | 2 | 3 |
Disable C.O.P. | Enable C.O.P. for | ||
|
| Athlon™ | XP |
|
| (Default) | |
|
|
| |
|
|
|
Motherboard Settings
3. H/W SETUP
ASUS | 21 |