4.Prepare hard disk drive. Carefully connect the SCSI-IDE HDD bridge board to the 40-1 pin IDE connector and 4-pin power connector. Make sure that the SCSI-IDE HDD bridge is properly connected.

5.Carefully place the hard disk drive into the drive tray. Align the four (4) screw holes on the drive with those on the tray rails. Secure drive with four round head screws.

6.Secure the SCSI-IDE HDD Bridge to the tray with two (2) round head screws.

7.Re-attach the rear bracket and secure it with two (2) flat head screws.

4

SCSI-IDE HDD bridge board

6

5

7

Do not overtighten the screws to avoid breaking the plastic tray rails.

8. To install the tray into the bay, follow steps 5, 6, and 7 in section 2.5.1.

ASUS AK35 chassis kit

2-15