7.Connect the IDE and power cables to their corresponding connectors on the back of the drive.

8.Follow steps 2 to 6 if you wish to install other hard disk drives.

9.Re-install the front panel assembly when done.

Installing into a bay on the second drive cage

To install an internal drive :

1.Remove the side cover. Refer to section 2.1.1 for instructions.

2.Use a Phillips (cross) screwdriver to attach Rail 2 to the side of the drive with two screws as shown. The rail handle should be on the side of the drive connectors.

Rail handle

Drive connectors

Hole 4

Hole 2

3.Attach Rail 1 to the side of the drive with two screws as shown. The rail handle should be on the side of the drive connectors.

Hole 2

Hole 4

Rail handle

Drive connectors

2-22

Chapter 2: Hardware setup