Installing an HDD dummy cover

Except on the 8-SCSI configuration model (AS8), the HDD dummy covers come pre-installed on the front panel bezel. In case you removed the covers, follow these steps to re-install them.

To install an HDD dummy cover:

1.From the inside of the front panel assembly, insert the flat end of a dummy cover into the slot as shown. The end with the hook tab should be close to the front panel LEDs.

Flat end

Hook tab

2.Press the dummy cover into the slot opening until the hook tab clicks in place.

3.When installed, the dummy cover appears as shown.

2-24

Chapter 2: Hardware setup