2.Keyboard/mouse power and USB device wake-up (3-pin PS2_USBPW1-4)

This jumper allows you to enable or disable the keyboard/mouse and USB port 1-4 wake-up feature. When you set this jumper to pins 2-3 (+5VSB), you can wake up the computer by pressing a key on the keyboard, clicking the mouse or using a USB device. This feature requires an ATX power supply that can supply at least 1A on the +5VSB lead, and a corresponding setting in the BIOS. The USBPW1-4 jumper is for the rear USB ports.

PS2_USBPW1-4

1

2

2

3

 

 

 

 

 

+5V +5VSB (Default)

AT5IONT-I DELUXE

AT5IONT-I DELUXE PS2 Keyboard/Mouse power setting and USB device wake-up

The total current consumed must NOT exceed the power supply capability (+5VSB) whether under normal condition or in sleep mode.

3.USB device wake-up (3-pin USBPW56)

Set this jumper to +5V to wake up the computer from S1 sleep mode (CPU stopped, DRAM refreshed, system running in low power mode) using the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep modes (no power to CPU, DRAM in slow refresh, power supply in reduced power mode).

USBPW56

AT5IONT-I DELUXE

 

3

2

2

1

 

+5V +5VSB (Default)

AT5IONT-I DELUXE USB Device Wake-up

•The USB device wake-up feature requires a power supply that can provide 500mA on the +5VSB lead for each USB port; otherwise, the system would not power up.

•The total current consumed must NOT exceed the power supply capability (+5VSB) whether under normal condition or in sleep mode.

1-7

Chapter 1: Product introduction