English

Chapter 2 - Quick Installation

2. 2 Hardware connection

Use a standard Category 5 (CAT5) Ethernet cable with RJ45 jack to connect the WAN port of AX-112 to the LAN port of your ADSL modem or router.

Use another Ethernet cable to connect your PC or notebook to the LAN port of AX-112 if necessary.

Use an ordinary phone cable with RJ11 jack to connect the phone-set to

AX-112’s phone port.

Use another phone cable with RJ11 jack to connect the AX-112’s line port to your PSTN jack if necessary. The PSTN jack is normally on the wall.

Connect the power adapter, and then refer to the next section for how to assign an IP address to the WAN port for future operation.

2. 3 WAN IP assignment

After you have correctly set up the hardware connection, the next step is the WAN port IP assignment. You may assign a fixed IP address to AX-112 or enable its DHCP client to get an IP address from your DHCP server.

At the first stage of assigning an IP address to the WAN port, you may get the IP address by using the phone-set and entering the proper DTMF code command. AX-112 will the report the WAN address for you by voice. You may access the WAN port’s IP address via IVR. Follow the instructions below:

1.Pick up the phone and dial “****”; and

2.After hearing the voice menu, dial “100#”. You should hear the WAN status reported by voice.

By default, the AX-112’s WAN port is set to the DHCP client mode. If there is no DHCP server in your network, you can assign a fixed IP address for AX-112 via IVR. Refer to the Chapter 4 for more information on how to configure the IVR.

12

AX-112 Analog Telephone Adapter