2.1Before you proceed
Take note of the following precautions before you install motherboard components or change any motherboard settings.
•Unplug the power cord from the wall socket before touching any component.
•Use a grounded wrist strap or touch a safely grounded object or a metal object, such as the power supply case, before handling components to avoid damaging them due to static electricity.
•Hold components by the edges to avoid touching the ICs on them.
•Whenever you uninstall any component, place it on a grounded antistatic pad or in the bag that came with the component.
•Before you install or remove any component, ensurethat the ATX power supply is switched off or the power cord is detached from the power supply. Failure to do so may cause severe damage to the motherboard, peripherals, and/or components.
Onboard LEDs
The motherboard comes with LEDs that indicate the voltage conditions of CPU, memory, northbridge, and southbridge. You may adjust the voltages in BIOS. There are also an LED for hard disk drive activity and an onboard switch for power status. For more information about voltage adjustment, refer to 4.4 Extreme Tweaker menu.
1.CPU LED
The CPU LE�D has two voltage displays: CPU Voltage and CPU PLL�� Voltage; you can select the voltage to display in BIOS. Refer to the illustration below for the location of the CPU LE�D and the table below for LE�D definition.
CPU_CRAZY
CPU_HIGH
CPU_NORMAL
STRIKER II FORMULA
STRIKER II FORMULA CPU LED
| Normal (green) | High (yellow) | Crazy (red) |
|
CPU Voltage | 1.10000~1.50000 |
| 1.70000~ |
|
1.50625~1.69375 |
| |||
CPU PLL Voltage | 1.50000~1.60000 | 1.62000~1.80000 | 1.82000~ |
|
|
|
|
|
|
ROG Striker II Formula |
|
| ||