STRIKER II FORMULA
PRI_IDE
NOTE: Orient the red markings (usually zigzag) on the ID� cable to PIN 1.
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 0+1, RAID 5, or JBODconfiguration with the NVIDIA® MediaShield™ RAID controller.
• These connectors are set to [Disabled] by default. In Standard IDE mode, you can connect Serial ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA RAID set using these connectors, enable the [RAID Enabled] item in the BIOS. See section 4.5.3 Onboard Devices Configuration for details.
•For RAID 5, use at least three hard disk drives. For RAID 0+1, use at least four hard disk drives. Use two to four Serial ATA hard disk drives for each RAID 0 or RAID 1 set.
•Before creating a RAID set, refer to 5.4.2 NVIDIA® RAID configurations or the manual bundled in the motherboard support DVD.
SATA6 | GND |
|
|
| GND |
|
|
| SATA5 |
|
|
|
|
|
| ||||
| RSATA_TXP6 |
|
|
| RSATA_TXP5 |
|
|
|
|
| RSATA_TXN6 |
|
|
| RSATA_TXN5 |
|
|
|
|
| GND |
|
|
| GND |
|
|
|
|
|
|
|
|
|
|
| |||
| RSATA_RXP6 |
|
|
| RSATA_RXP5 |
|
|
|
|
|
|
|
|
|
|
| |||
| RSATA_RXN6 |
|
|
| RSATA_RXN5 |
|
|
|
|
|
|
|
|
|
|
| |||
| GND |
|
|
| GND |
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| SATA4 | GND | GND |
|
| RSATA_TXP4 | RSATA_TXP3 |
|
| RSATA_TXN4 | RSATA_TXN3 |
|
| GND | GND |
|
| RSATA_RXP4 | RSATA_RXP3 |
|
| RSATA_RXN4 | RSATA_RXN3 |
|
| GND | GND |
STRIKER II FORMULA | SATA2 | GND | GND |
|
| RSATA_TXP2 | RSATA_TXP1 |
|
| RSATA_TXN2 | RSATA_TXN1 |
|
| GND | GND |
|
| RSATA_RXP2 | RSATA_RXP1 |
|
| RSATA_RXN2 | RSATA_RXN1 |
|
| GND | GND |
SATA3
SATA1
ROG Striker II Formula |