6.System panel connector (10-1 pin F_PANEL)

This connector supports several chassis-mounted functions.

F_PANEL

E35M1-I DELUXE

PLED PWRBTN

GND PWR PLED- PLED+

Reset

Ground

IDE_LED-

IDE_LED+

PIN 1

+HDLED RESET

E45M1-I DELUXE System panel connector•System power LED (2-pin PLED)

This 2-pin connector is for the system power LED. Connect the chassis power LED cable to this connector. The system power LED lights up when you turn on the system power, and blinks when the system is in sleep mode.

•Hard disk drive activity LED (2-pin +HDLED)

This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED cable to this connector. The IDE LED lights up or flashes when data is read from or written to the HDD.

•Power/Soft-off button (2-pin PWRBTN)

This 2-pin connector is for the system power button.

•Reset button (2-pin RESET)

This 2-pin connector is for the chassis-mounted reset button for system reboot without turning off the system power.

7.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

E35M1-I DELUXE

CHASSIS

+5VSB MB

Chassis Signal GND

 

 

 

 

 

 

 

 

 

 

E45M1-I DELUXE Chassis intrusion connector

1-14

ASUS E45M1-I DELUXE