Asus M2A-MVP Mode of, device(s), M2A-MVPSATA connectors, 3.Serial ATA connectors, 2.3.5 Storage Configuration, (7-pinSATA1[red], SATA2 [red], SATA3 [black], SATA4 [black]

	Drive jumper setting	Mode of	Cable connector
		device(s)
Single device	Cable-Select or Master	—	Black
	Cable-Select	Master	Black
Two devices		Slave	Gray
	Master	Master	Black or gray
	Slave	Slave

If any device jumper is set as “Cable-Select,” make sure all other device jumpers have the same setting.

3.Serial ATA connectors(7-pin SATA1[red], SATA2 [red], SATA3 [black], SATA4 [black]

These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.

If you installed Serial ATA hard disk drives, you can can create a

RAID 0, RAID 1, and RAID 0+1 configuration. Refer to Chapter 3 for information on creating a RAID configuration.

Enable the Serial ATA Controller and Onboard SATA Boot ROM items in the BIOS if you want to use the Serial ATA RAID feature. See section 2.3.5 Storage Configuration for details.

M2A-MVP

M2A-MVP SATA connectors

GND RXN2_RSATA RXP2_RSATAGND TXN2_RSATA TXP2_RSATAGND

SATA2 GNDRXN4_RSATARXP4_RSATAGNDTXN4_RSATATXP4_RSATAGND

GND RXN1_RSATA RXP1_RSATAGND TXN1_RSATA TXP1_RSATAGND

SATA1 GNDRXN3_RSATARXP3_RSATAGNDTXN3_RSATATXP3_RSATAGND

SATA4 SATA3

ASUS M2A-MVP 1-29