Asus M2A-MVP Serial ATA hard disk drive connection, Use, Color, Setting, Connector, M2A-MVPChassis intrusion connector, 4.Chassis intrusion connector (4-1pin CHASSIS)

• Plug your Serial ATA boot disk on the master port (SATA1/2 to support S3 function).

•Install the Windows® 2000 Service Pack 4 or the Windows® XP Service Pack1 or later when using Serial ATA.

Serial ATA hard disk drive connection

Connector	Color	Setting	Use
SATA1/SATA2	Red	Master	Boot disk
SATA3/SATA4	Black	Slave	Data disk

4.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

CHASSIS

M2A-MVP

+5VSB MB Chassis Signal GND

(Default)

M2A-MVP Chassis intrusion connector

1-30 Chapter 1: Product introduction