INSTALLATION .III (Connectors)

III.INSTALLATION

5.Floppy Drive Connector (34-pin block )

This connector supports the provided floppy drive ribbon cable. After connect- ing the single end to the board, connect the two plugs on the other end to the floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta- tion when using ribbon cables with pin 5 plugged).

Pin 1

Connect the Red stripe to Pin 1

Floppy Drive Connector

6.Power Connector (12-pin block)

This connector connects to a standard 5 Volt power supply. To connect the leads from the power supply, ensure first that the power supply is not plugged. Most power supplies provide two plugs (P8 and P9), each containing six wires, two of which are black. Orient the connectors so that the black wires are located in the middle.

Using a slight angle, align the plastic guide pins on the lead to their receptacles on the connector. Once aligned, press the lead onto the connector until the lead locks into place.

 

 

 

 

 

 

PG

 

 

ORG

+5V

 

 

 

 

 

 

P8

RED

 

 

 

 

 

 

 

 

+12V

 

YLW

-12V

 

 

 

 

 

 

BLU

 

 

 

 

 

 

 

 

 

BLK

 

 

 

 

 

 

GND

 

 

BLK

 

 

 

 

 

 

 

 

BLK

 

 

 

 

 

 

 

 

 

BLK

 

 

 

 

 

 

 

 

 

WHT

-5V

 

 

 

 

 

P9

RED

 

 

 

 

 

 

 

 

 

 

 

 

RED

 

 

 

 

 

 

+5V

 

 

RED

 

 

 

 

 

Power Connector

 

Power Plugs from

 

on Motherboard

 

Power Supply

 

Power Connector

20

ASUS P/I-P55T2P4S User’s Manual