III.INSTALLATION

7.Primary / Secondary IDE Connectors (Two 40-pin Block)

These connectors support the provided IDE hard disk ribbon cable. After connecting the single end to the board, connect the two plugs at the other end to your hard disk(s). If you install two hard disks, you must configure the second drive to Slave mode by setting its jumper accordingly. Please refer to the documentation of your hard disk for the jumper settings. BIOS now supports SCSI device or IDE CD-ROM bootup (see "HDD Sequence SCSI/IDE First" & "Boot Sequence" in the BIOS Features Setup of the BIOS SOFTWARE) (Pin 20 is removed to prevent inserting in the wrong orientation when using ribbon cables with pin 20 plugged).

TIP: You may configure two hard disks to be both Masters using one ribbon cable on the primary IDE connector and another ribbon cable on the secondary IDE connector. You may install one operating system on an IDE drive and another on a SCSI drive and select the boot disk through BIOS Features Setup.

Pin 1

Connect the Red stripe to Pin 1

Secondary IDE Connector

Primary IDE Connector

IDE (Hard Drive) Connectors

8.IDE Activity LED (HDLED)

This 2-Pin lead will light up a case LED whenever there is read/write activity by devices connected to the IDE and/or SCSI connectors.

TIP: If the case-mounted LED does not light, try reversing the 2-Pin plug.

HD LED

+

Hard Drive LED Lead

INSTALLATION

(Connectors)

III.

 

 

 

ASUS P/I-P55T2P4S User’s Manual

21