III.INSTALLATION

2.Mount the Heatsink: Place the SEC cartridge face down on a flat surface and lay the heatsink flush on the back (metal side) of the SEC cartridge. Be sure that the heatsink is firmly pressed against the SEC cartridge. When correctly installed, no light can be seen between the thermal pad of the heatsink and the SEC car- tridge.

IMPORTANT: The heatsinks must not be more than 2.8 cm (1.1 inch) thick.

WARNING! If the heatsink is not mounted tightly against the SEC cartridge, the CPU will overheat. You may install an auxiliary fan to provide adequate circulation across the processor’s passive heatsink.

Push each end of the clamps until they lock

Lock

 

 

 

Lock

 

 

The thermal pad & SEC cartridge should not have a gap!

SEC Cartridge with Heatsink (Top View)

3.Insert the SEC Cartridge: Push the SEC cartridge’s two locks inward until you hear a click (the preceding picture shows the locks in the outward position and inward in the picture below). With the heatsink facing the motherboard’s chipset, press the cartridge gently but firmly until it is fully inserted. (NOTE: The procedures shown here are for installing the AAVID heatsink with fan.)

Push lock inward

INSTALLATION

CPU

III.

 

 

 

ASUS P2B-D2 User’s Manual

21