INSTALLATION .III CPU

III. INSTALLATION

IMPORTANT: If you are installing only one processor, you must terminate the empty slot with the ASUS C-P2T PC100 CPU termination card to maintain signal strength.

ASUS C-P2T PC100 CPU Termination Card

IMPORTANT: Use only the ASUS C-P2T PC100 CPU termination card (Rev. 1.02 or later) to terminate the empty slot.

4.Secure the SEC Cartridge: Secure the SEC cartridge in place by pushing the SEC cartridge locks outward so that the lock protrudes through the retention mechanism’s lock holes.

Lock protrudes through hole when cartridge is secured

5.Connect the Heat Sensor Cable to J1601/J1602: If you purchased the spe- cially designed Pentium II processor fan with thermal monitor, you may connect the heat sensor cables to the motherboard’s CPU heat sensor connectors (J1601/ J1602).

NOTE: If you are installing only one processor, you may use the free connector to connect a power supply with thermal monitoring.

J1601

Heat Sensor Connector for CPU 1

J1602

Heat Sensor Connector for CPU 2

P2B-D2 CPU Heat Sensor Connectors

22

ASUS P2B-D2 User’s Manual