SETUP H/W .3

Connectors

3.HARDWARE SETUP

4)Front Panel Microphone Connector (2-pin MIC-CON)

This connector is used to connect the front panel microphone jack to the moth- erboard through a ribbon cable.

NLX-R (Front)

NLX-R

 

The front panel’s 1/8” microphone

B9-N (Front)

jack connects to the riser card

through a ribbon cable

B9-N

Yeong-Yang (Front)

YEONG-YANG

Front Panel Microphone Jack

5)NLX Power Supply Connector (20-pin block)

This connector connects to an NLX power supply. The plug from the power sup- ply will only insert in one orientation because of the different size holes. Find the proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that the NLX power supply can deliver at least 720mA on the 5volt standby lead (+5VSB). You may experience difficulty in powering ON your system without this specification.

NLX-R (Back)

B9-N (Back)

+5.0 Volts

+5.0 Volts

-5.0 Volts

Ground

Ground

Ground

Power Supply On

Ground

-12.0 Volts

+3.3 Volts

 

 

 

 

 

 

 

 

 

 

Yeong-Yang (Back)

+12.0Volts

+5VStandby

PowerGood

Ground

+5.0 Volts

Ground

+5.0 Volts

Ground

+3.3 Volts

+3.3 Volts

 

 

 

 

 

 

 

 

 

 

NLX Power Supply Connector

38

ASUS P2B-N User’s Manual