Asus P2L97 Installing the Processor, NOTE:, of your processor, SECC with Pentium®, 2. Attach the Heatsink, Unlock the URM’s Folding Support Arms:

SECC2/SEPP Heatsink Clip Legs

III. INSTALLATION

Installing the Processor

1.Unlock the URM’s Folding Support Arms: The folding support arms of the URM are locked when shipped.

To unlock the support arms, simply flip them up to an upright position.

Locked Folding Support Arms

INSTALLATION .III CPU

The URM is now ready for the installation	Unlocked Folding
of your processor.	Support Arms

2. Attach the Heatsink

NOTE: Follow carefully the heatsink attachment instructions included with your heatsink or processor. The following steps are provided only as a general guide and may not reflect those for your heatsink.

SECC with Pentium® II

Place the SECC face down on a flat surface		Push each end of the clamps until they lock
and lay the heat sink flush on the back (metal	Lock		Lock
side) of the SECC. Check the orientation of
the heatsink against the illustration below.
The thicker fin must be orientated toward the

bottom. The top clamp is wider than the bottom clamp so only this orientation will fit. With a screw driver, push the clamps one at a time into the SECC. Be sure that the heatsink is firmly pressed against the SECC.

SECC2withPentium® II/SEPPwith Celeron™

Insert the heatsink clip through the holes at the SECC2/SEPP’s back, making sure that the bottom of the clip plate sits against the processors’s back. Remove the tab from the thermal grease,

which is located on the bottom of the heatsink)

and place the heatsink over the processor. A slight rocking motion may be necessary to place the heatsink on the SECC2/SEPP, with one pair of the heatsink clip legs going first through the corresponding heatsink holes, and then the other pair. (NOTE: The heatsink and SECC2/SEPPholes are slightly offset to ensure good locking grip between the two.)

20 ASUS P2L97 User’s Manual