Page
USER'S NOTICE
Product Name:
ASUS P2Z-VM
Manual Revision:
1.02 E352
ASUSTeK COMPUTER INC. (Asia-Pacific)
Marketing
Technical Support
ASUS COMPUTER INTERNATIONAL (America)
ASUS COMPUTER GmbH (Europe)
CONTENTS
Page
FCC & DOC COMPLIANCE
Federal Communications Commission Statement
•This device may not cause harmful interference, and
•Re-orientor relocate the receiving antenna
•Increase the separation between the equipment and receiver
How this Manual is Organized
Item Checklist
Features of the ASUS P2Z-VMMotherboard
II.FEATURES
Wake-On-LAN:
IrDA:
Special Features:
Enhanced ACPI and
Intelligent Features:
Auto Fan Off:
even in sleep mode
and
system noise
The ASUS P2Z-VMMotherboard
Layout of the ASUS P2Z-VMMotherboard
Jumpers
Expansion Slots
Connectors
Layout Contents
Hardware Setup Steps
1. Motherboard Settings
Jumpers
III.HARDWARE SETUP
2.VGA Setting (VGAEN)
VGAEN
(default)
3.Keyboard Power (Wake) Up (KB_WAK)
4.Audio Setting (AUDIO_EN)
The onboard 32-bitPCI audio may be enabled or disabled using this jumper
5.CPU Bus Frequency Selection (FS0, FS1, FS2, FS3, FS4)
External
BUS Clock
6.CPU Core:BUS Frequency Multiple (BF0, BF1, BF2, BF3)
Set the jumpers by the Internal speed of your processor as follows:
NOTES:
Page
2.System Memory (DIMM)
DIMM Memory Installation Procedures:
3.Central Processing Unit (CPU)
Universal Retention Mechanism
Heatsinks
Installing the Processor
3.Insert the SECC/SECC2/SEPP
SECC with Pentium
II only:
4.Secure the SECC/SECC2/SEPP
Recommended Heatsinks for Slot 1 Processors
4.Expansion Cards
Expansion Card Installation Procedure
Assigning IRQs for Expansion Cards
Assigning DMA Channels for ISA Cards
Accelerated Graphics Port
5.External Connectors
3.Parallel Port Connector (25-pinPRINTER)
NOTE
4.Serial Port COM1 Connector (9-pinCOM1)
5.Monitor (VGA) Output Connector (15-pinVGA)
Audio Port Connectors (Three 1/8” Female)
Line Out
Line In
Mic
9.Primary / Secondary IDE Connectors (Two 40-1pinIDE)
10.Floppy Disk Drive Connector (34-1pinFLOPPY)
11.IrDA-CompliantInfrared Module Connector (5-pinIR)
12.Wake-On-LANConnector (3-pinWOL_CON)
WAKE On LAN
Power Up Con- trol
do not place jumper caps over these pins
14.SB-Link™Connector (6-1pin SB-LINK)
15.Internal Audio Connectors (4-pinCD_IN and MODEM_IN)
16.Serial Port COM 2 Header (10-1pin COM2)
17.Message LED Lead (2-pinMLED)
18.Keyboard Lock Switch Lead (2-pinKEYLOCK)
19.System Management Interrupt Lead (2-pinSMI)
21.ATX Power Switch/Soft Power Switch (2-pinPWR)
22.IDE Activity LED (2-pinIDELED)
25.ATI Multimedia Channel Connector (40-3pin AMC)
26.ATX Power Supply Connector (20-pinblock ATXPWR)
Page
Power Connection Procedures
Flash Memory Writer Utility
Main Menu
2. Update BIOS Including Boot Block and ESCD
Flash Memory Writer
Managing and Updating Your Motherboard’s BIOS
6. BIOS Setup
Load Defaults
Standard CMOS Setup
Details of Standard CMOS Setup:
Time
(Hour: (00 to 23), Minute: (00 to 59), Second: (00 to 59)
Hard Disks
For IDE hard disk drive setup, you can:
•Use theAuto setting for detection during bootup
Auto detection of hard disks on bootup
Drive A
Floppy 3 Mode Support
Drive A, Drive B, Both, and Disabled
Video
BIOS Features Setup
Details of BIOS Features Setup
Features BIOS
Processor Serial Number (Enabled)
CPU Level 1 Cache / CPU Level 2 Cache (Enabled)
CPU Level 2 Cache ECC Check (Disabled)
This function controls the ECC check capability in the CPU level 2 cache
PS/2 Mouse Function Control (Auto)
OS/2 Onboard Memory > 64M (Disabled)
PCI/VGA Palette Snoop (Disabled)
Video ROM BIOS Shadow (Enabled)
C8000-CBFFFto DC000-DFFFF(Disabled)
Chipset Features Setup
Details of Chipset Features Setup
Timing for 16-bitand 8-bitISA cards, respectively. Leave on default setting
Graphics Aperture Size (64MB)
Video Memory Cache Mode (UC)
USWC
PCI 2.1 Support (Enabled)
Features Chipset
Parallel Port Mode (ECP+EPP)
ECP DMA Select (3)
ECP
ECP+EPP
Power Management Setup
Details of Power Management Setup
Video Off Method (DPMS OFF)
DPMS OFF
DPMS Reduce ON
Blank Screen
V/H SYNC+Blank, DPMS Standby
PWR Up On Modem Act (Enabled)
AC PWR Loss Restart (Disabled)
Disabled
Power Up By Keyboard (Disabled)
Wake On LAN (Disabled)
PNP and PCI Setup
Details of PNP and PCI Setup
DMA x Used By ISA (No/ICU)
ISA MEM Block BASE (No/ICU)
SYMBIOS SCSI BIOS (Auto)
USB IRQ (Enabled)
ONB VGA BIOS First (No)
Load BIOS Defaults
Load Setup Defaults
Supervisor Password and User Password
IDE HDD Auto Detection
Hard Disk Detect
Save & Exit Setup
Exit Without Saving
Page
SOFTWARE CONTENTS
V. SOFTWARE SETUP
VI. SOFTWARE REFERENCE
Windows 98 First Time Installation
Installing Plug-and-PlayHardware
Onboard Audio
Onboard Video
P2Z-VMSupport CD Autorun Screen
Installing the Video Driver and Utility
Making Monitor Adjustments
Adjustment Page
Color Page
Displays Page
Installing Audio Utilites
Installing the Software Wavetable
Installing PCCillin
Page
ATI Player
Task Control Panel
Audio CD Player
To Play Audio CDs
MPEG Player
TV Tuner
Teletext
Capture
Capturing Still Images from Television
Capturing Still Images from MPEG Clips
Capturing a Sequence of Frames
Capturing a Stream of Video and Audio
AudioRack32
Rack
The AudioRack32 has five main parts:
AudioRack32
•Digital Audio Player—playsand records files in the .WAV format
The Command Center
The Command Center Controls
The Command Center Display
The Miniature Mode
The Compact Disk Player
The Compact Disk Player Controls
The Audio Mixer
The Audio Mixer Controls
The Digital Audio Player
The Digital Audio Player Controls
The Digital Audio Player Display
The MIDI Player
The MIDI Player Controls
The MIDI Player Display
The Audio Recorder
The Audio Recorder Controls
The Audio Recorder Display
Release Notes
Disable Eject Button on the CD Player
Using AudioRack CD Player as Default CD Player
Configuring Playback Mixer
The ASUS S370 CPU Card
Using the ASUS S370
Setting up the ASUS S370
370Socket
ASUS S370 Jumper Settings
ASUS PCI-L101Fast Ethernet Card
Features
Software Driver Support
Question and Answer
Glossary
Byte (Binary Term)
COM Port
CPU (Central Processing Unit)
Device Driver
DOS (Disk Operating System)
MMX
(Klamath) CPU as well as other
PCI Bus (Peripheral Component Interconnect Local Bus)
Peripherals
POST (Power On Self Test)
Ultra DMA/33
USB (Universal Serial Bus)