3.HARDWARE SETUP

2.Attach the Heatsink

NOTE: If provided, you should follow the heatsink attachment instructions that came with your heatsink or processor. The following steps are provided only as a general guide and may not reflect those for your heatsink.

Using SECC fan with Pentium® II Push the two lock arms one direction to clamp the heatsink onto the processor and the other direction to release.

Lock Arm

Lock Arm

Using SECC2 fan with Pentium® III

Insert the four heatsink’s pins through the holes of the SECC2. Place the metal clip on the ends of the pins and slide until it locks into place.

.3 SETUP H/WCPU

Four Pins and metal clip

WARNING! Make sure the heatsink is mounted tightly against the SECC2, SECC, or SEPP; otherwise, the CPU will overheat. You may install an auxiliary fan to provide adequate circulation across the processor’s passive heatsink.

NOTE: The SEPP heatsink and fan (for Intel Celeron processors) is similar to the SECC2 heatsink and fan except that the clamping design is different.

3.Insert the SECC2/SECC/SEPP

SECC with Pentium® II only: Push the SECC’s two locks inward until you hear a click (the picture in step 2 shows the locks in the outward position and inward in the picture below).

With the heatsink facing the motherboard’s chipset, push the SECC2, SECC, or SEPP gently but firmly into the Slot 1 connector until it is fully inserted.

SECC

SECC2/SEPP

Push lock inward

CPU fan cable to

CPU fan cable to

fan connector

fan connector

28

ASUS P3W User’s Manual