Asus P5N-D P5N-DIEEE 1394a connector, P5N-DChassis intrusion connector, 5.IEEE 1394a port connector (10-1pin IE1394_2), 6.Chassis intrusion connector (4-1pin CHASSIS)

5.IEEE 1394a port connector (10-1 pin IE1394_2)

This connector is for a IEEE 1394a port. Connect the IEEE 1394a module cable to this connector, then install the module to a slot opening at the back of the system chassis.

P5N-D

IE1394_2
P5N-D IEEE 1394a connector	GND

-TPA1 TPA1+ GND GND -TPB1 TPB1+ +12V +12V

PIN 1

Never connect a USB cable to the IEEE 1394a connector. Doing so will damage the motherboard!

You can connect the 1394 cable to ASUS Q-Connector (1394, red) first, and then install the Q-Connector (1394) to the 1394 connector onboard.

The IEEE 1394a module cable is purchased separately.

6.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default , the pin labeled “Chassis Signal” and “ Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5N-D	MB	Signal
	+5VSB_	Chassis	GND

	CHASSIS
	(Default)
	P5N-D Chassis intrusion connector
2-30	Chapter 2: Hardware information