5.4.4Marvell® SAS RAID configurations

The Marvell® 88SE6320 SAS controller allows you to configure RAID 0, RAID 1, and RAID 10 set(s) on the SAS hard disk drives.

Setting the RAID item in BIOS

You must set the RAID item in the BIOS Setup before you can create a RAID set. To do this:

1.Install two internal SAS hard disk drives to the SAS connectors labeled SAS1/2.

2.Boot up your computer, and press <Del> during POST to enter the BIOS setup.

3.In the Advanced menu, go to Onboard Devices Configuration, and enable both Marvell 6320/SAS and 6320 Boot ROM.

4.Press <F10> to save the changes and exit.

 

 

 

BIOS SETUP UTILITY

 

 

 

 

Advanced

 

 

 

 

 

Onboard Device Configuraiton

 

 

Enable or Disable

 

High Definition Audio

[Enabled]

High Definition Audio

 

Controller

 

 

 

 

 

 

OnChip LAN1

[Auto]

 

 

 

OnChip LAN2

[Auto]

 

 

 

LAN Boot ROM

[Disabled]

 

 

 

Marvell 6121/eSATA

[Legacy Mode]

 

 

 

6121 Boot ROM

[Enabled]

 

 

 

 

Marvell 6320/SAS

[Enabled]

 

 

 

 

6320 Boot ROM

[Enabled]

 

 

 

 

Onboard 1394

[Enabled]

 

 

Select Screen

 

Serial Port1 Address

[3F8/IRQ4]

 

 

 

Select Item

 

 

 

 

 

 

 

 

 

 

 

+-

Change Option

 

 

 

 

 

F1

General Help

 

 

 

 

 

F10

Save and Exit

 

 

 

 

 

ESC

Exit

v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.

The RAID BIOS setup screens shown in this section are for reference only, and may not exactly match the items on your screen.

5-54

Chapter 5: Software support