10.Wireless LAN ports. These ports are on the onboard wireless LAN module that allow you to set up a wireless network and exchange information with other wireless devices without tagling cables and wires. Connect the moveable
11.Wireless LAN Activity LED. The wireless module comes with an activity LED.
12.Microphone port (pink). This port connects a microphone.
13.Side Speaker Out port (gray). This port connects the side speakers in an
Refer to the audio configuration table below for the function of the audio ports in 2, 4, 6, or
Port | Headset | ||||
|
|
|
| ||
Light Blue | Line In | Line In | Line In | Line In | |
Lime | Line Out | Front Speaker Out | Front Speaker Out | Front Speaker Out | |
Pink | Mic In | Mic In | Mic In | Mic In | |
Orange | – | – | Center/Subwoofer | Center/Subwoofer | |
Black | – | Rear Speaker Out | Rear Speaker Ou | Rear Speaker Out | |
Gray | – | – | – | Side Speaker Out |
14.USB 2.0 ports 1 and 2. These two
15.External SATA ports. These ports connect to external Serial ATA hard disk drives. To configure a RAID 0, 1, 5 or 10 set, install two external Serial ATA hard disk drives or the
• Before creating a RAID set using external Serial ATA hard disks, make sure that you have connected the external Serial ATA signal cables and installed external Serial ATA hard disk drives; otherwise, you cannot enter the Marvell RAID utility during POST.
•If you intend to create a RAID set using the external SATA ports, set the Marvell 6121/eSATA item in the BIOS to [RAID Mode]. See section
4.5.4 OnBoard Device Configuration and 5.4.3 Marvell® eSATA RAID configurations for details.
• DO NOT insert different connectors to these ports.
• DO NOT unplug the external Serial ATA drives when a RAID set is configured.
Chapter 2: Hardware information |