5.4.2NVIDIA¨ RAID configurations

The motherboard includes a high performance IDE RAID controller integrated in the NVIDIA¨ nForceª 4 SLI southbridge chipset. It supports RAID 0, RAID 1, RAID 0+1, RAID 5 and JBOD that spans across two Parallel ATA and four independent Serial ATA channels.

Setting the BIOS RAID items

After installing the hard disk drives, make sure to set the necessary RAID items in the BIOS before setting your RAID configuration.

To set the BIOS RAID items:

1.Boot the system and press <Del> during the Power-On Self-Test (POST) to enter the BIOS Setup Utility.

2.From the Advanced > Onboard Devices Configuration > NVRAID Configuration menu item in the BIOS set the RAID Enabled item to Enabled. The succeeding items become user-configurable.

3.Select and enable the IDE or SATA drive(s) that you want to configure as RAID. See section Ò4.4.8 Onboard Devices ConfigurationÓ for details.

4.Save your changes and Exit Setup.

Make sure to re-enter your NVRAID settings after the CMOS is cleared; otherwise, the system will not recognized your RAID setup.

¥ For detailed descriptions on the NVIDIA¨ RAID configuration, refer to the ÒNVIDIA¨ RAID UserÕs ManualÓ found in your motherboard support CD.

¥When using Windows 2000 operating system, make sure to install the Windows 2000 Service Pack 4 or later versions.

ASUS P5ND2-SLI Series

5 - 23