2. I DE connectors (40-1 pi n PRI _I DE, SEC_I DE)

These connectors are for Ultra DMA 100/66/33 signal cables. There are three interfaces on each Ultra DMA 100/66/33 signal cables: blue, black, and gray. Connect the blue interface into the motherboad’s IDE connector, then select the following modes to configure your hard disk drive(s).

 

Drive Jumper Setting

Mode of Devices

Cable Connector

 

 

 

 

Single device

Cable-select or Master

-

Black

Two devices

Cable-select

Master

Black

 

 

Slave

Gray

 

Master

Master

Black or gray

 

Slave

Slave

 

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

•Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices.

If any device jumper is set to “Cable-select”, make sure all other device jumpers have the same setting.

VM

PRI IDE

P5PE-

 

P5PE-VM IDE Connectors

SEC_IDE

ASUS P5PE-VM

1-25