1.7.2Memory configurations

You may install 512MB, 1GB, 2GB, and 4GB unbuffered non‑ECC DDR3 DIMMs into the DIMM sockets.

• You may install varying memory sizes in Channel A and Channel B. The system maps the total size of the lower-sized channel for the dual-channel configuration. Any excess memory from the higher-sized channel is then mapped for single-channel operation.

•Due to Intel spec definition, X.M.P. DIMMs are supported for one DIMM per channel only.

•According to Intel CPU spec, DIMM voltage below 1.65V is recommended to protect the CPU.

•According to Intel CPU spec, CPUs with a core frequency of 2.66G support the maximum DIMM frequency of up to DDR3-1333. To use DIMMs of a higher frequency with a 2.66G CPU, enable the DRAM O.C. Profile feature in BIOS. Refer to section 2.4 Ai Tweaker menu for details.

•Always install DIMMs with the same CAS latency. For optimum compatibility, we recommend that you obtain memory modules from the same vendor.

•Due to the memory address limitation on 32-bit Windows® OS, when you install 4GB or more memory on the motherboard, the actual usable memory for the OS can be about 3GB or less. For effective use of memory, we recommend that you do any of the following:

-Use a maximum of 3GB system memory if you are using a 32-bit Windows® OS.

-Install a 64-bit Windows® OS when you want to install 4GB or more on the motherboard.

•This motherboard does not support DIMMs made up of 512Mb (64MB) chips or less.

• The default memory operation frequency is dependent on its Serial Presence Detect (SPD), which is the standard way of accessing information from a memory module. Under the default state, some memory modules for overclocking may operate at a lower frequency than the vendor-marked value. To operate at the vendor-marked or at a higher frequency, refer to section 2.4 Ai Tweaker menu for manual memory frequency adjustment.

•For system stability, use a more efficient memory cooling system to support a full memory load (4 DIMMs) or overclocking condition.

1-14

Chapter 1: Product introduction