EPP Version [1.9]
Appears only when the Parallel Port Mode item is set to [EPP]. This item allows you to select the EPP version. Configuration options: [1.9] [1.7]
Parallel Port IRQ [IRQ7]
Allows you to select parallel port IRQ. Configuration options: [IRQ5] [IRQ7]
2.5.4USB Configuration
The items in this menu allows you to change the
The Module Version and USB Devices Enabled items show the
USB Functions [Enabled]
Allows you to disable or enable the USB functions. Configuration options: [Disabled] [Enabled]
Legacy USB Support [Auto]
Allows you to enable or disable support for Legacy USB storage devices, including USB flash drives and USB hard drives. Setting to [Auto] allows the system to detect the presence of USB devices at startup. If detected, the USB controller legacy mode is enabled. If no USB device is detected, the legacy USB support is disabled. Configuration options: [Disabled] [Enabled] [Auto]
BIOS EHCI Hand-off [Enabled]
Allows you to enable or disable the BIOS EHCI
Configuration options: [Disabled] [Enabled]
The following items may only appear when a USB storage device is plugged.
USB Mass Storage Device Configuration
USB Mass Storage Reset Delay [20 Sec]
Allows you to set the maximum time that the BIOS waits for the USB storage device to initialize. Configuration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation Type [Auto]
Allows you to set the emulation type. Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk] [CDROM]
Chapter 2: BIOS information |