Asus si r2.0, P8H61-m2, tpm manual Sata Configuration, System Agent Configuration

2.5.4SATA Configuration

While entering Setup, the BIOS automatically detects the presence of SATA devices. The SATA Port items show Empty if no SATA device is installed to the corresponding SATA port.

SATA Mode Selection [IDE]

Allows you to set the SATA configuration.

[Disabled]	Disables the SATA function.
[IDE]	Set to [IDE] when you want to use the Serial ATA hard disk drives as
	Parallel ATA physical storage devices.
[AHCI]	Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
	(Advanced Host Controller Interface). The AHCI allows the onboard storage
	driver to enable advanced Serial ATA features that increases storage
	performance on random workloads by allowing the drive to internally
	optimize the order of commands.
	• Due to H61 Chipset limitation, AHCI Mode only works on Windows® Vista / Windows® 7.
	Please use IDE Mode on Windows® XP.
	• [IDE] is the default SATA type. Under Windows® XP, there is no need to change the
	SATA type.

S.M.A.R.T. Status Check [Enabled]

S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor system. When read/write of your hard disk errors occur, this feature allows the hard disk to report warning messages during the POST. Configuration options: [Enabled] [Disabled]

Hot Plug [Disabled]

This item only appears when you set the SATA Mode Selection item to [AHCI] and allows you to enable or disable the hot-plug support for each SATA port. Configuration options: [Enabled] [Disabled]

2.5.5System Agent Configuration

Memory Remap Feature [Enabled]

[Enabled]	Allow you to enable remapping the memory above 4GB.
[Disabled]	Disables this function.

Graphics Configuration

Primary Display [Auto]

Allows you to decide which graphics controller to use as the primary boot device. Configuration options: [Auto] [iGPU] [PCIE] [PCI]

iGPU Memory [Auto]

Allows you to set the iGPU memory size. Configuration options: [Auto] [32M] [64M] [96M] [128M] ~ [448M] [480M] [512M] [1024M]

Render Standby [Enabled]

Allows you to enable or disable Render Standby by internal graphics devices. Configuration options: [Disabled] [Enabled]

Chapter 2: BIOS information 2-17

E7361_P8H61-M2-TPM-SI R2.0_Manua17 17

5/16/12 1:45:03 PM