6.3.6Exiting the Intel® Rapid Storage Technology utility

To exit the utility:

1.From the utility main menu, select 5. Exit, and then press <Enter>. The following warning message appears.

[ CONFIRM EXIT ]

Are you sure you want to exit? (Y/N):

2.Press <Y> to exit or press <N> to return to the utility main menu.

6.3.7Rebuilding the RAID

This option is only for the RAID 1 set.

Rebuilding the RAID with other non-RAID disk

If any of the SATA hard disk drives included in the RAID 1 array failed, the system displays the status of the RAID volume as “Degraded” during POST. You can rebuild the RAID array with other installed non-RAID disks.

To rebuild the RAID with other non-RAID disk:

1.At the prompt, press <Ctrl> + <I> to enter the Intel Rapid Storage Technology option ROM utility.

2.If there is a non-RAID SATA Hard Disk available, the utility will prompt to rebuild the RAID. Press <Enter>, and then use up/down arrow keys to select the destination disk or press <ESC> to exit.

[ DEGRADED VOLUME DETECTED ]

"Degraded" volume and disk available for rebuilding detected. Selecting a disk initiates a rebuild. Rebuild completes in the operating system.

Select the port of destination disk for rebuilding (ESC to exit):

Port Drive Model

Serial #

Size

X

XXXXXXXXXXX

XXXXXXXX

XX.XGB

 

[↑↓]-Previous/Next

[ENTER]-Select [ESC]-Exit

Select a destination disk with the same size as the original hard disk.

ASUS RS700-X7/PS4

6-31