VI. ASUS PCI-SC200 SCSI Card

Setting the INT Assignment

You must use PCI INT A setting in order to properly assign the card's interrupt. On the ASUS PCI-SC200, you assign the INT by setting jumper JP1 or JP2. The default setting for the card already is INT A, so you do not need to change the setting to use the ASUS PCI-SC200 with this motherboard.

JPJP

JPJP

JPJP

JPJP

1

2

1

2

1

2

1

2

 

1

 

 

1

1

 

1

 

2

 

 

2

2

 

2

 

3

 

 

3

3

 

3

INT A (Def)

INT B

INT C

INT D

Interrupt Settings (A, B, C, or D)

 

 

Terminator Settings

SCSI devices are connected together in a “chain” by cables. Internal devices connect to the ASUS PCI-SC200 with a fifty-pin flat ribbon cable. External devices connect to the external port with a SCSI-2 cable. If there are more than one internal or external devices, additional devices are connected with cables to form a “daisy chain.” The SCSI chain must be “terminated” at both ends, or the devices in the chain will not work properly.

Many SCSI devices use a set of terminating resistors to terminate the device. The ASUS PCI-SC200 has “active” termination that you set using jumper JP5. If you need to terminate the ASUS PCI-SC200, you do it by setting the jumper. The are two settings, "terminated" and "not terminated," as shown below.

ASUS PCI-SC200

(Jumpers)

VI.

 

 

 

JP

JP

5

5

Terminated (Default)

Not Terminated

Terminator Setting (Terminated / Not Terminated)

ASUS TX97-E User’s Manual

61