Asus V2-PE2 COM Port Connector, Chassis Intrusion Connector, 11. Serialport connector (10-1pin COM2), 10. Chassis intrusion connector (4-1pin CHASSIS)

10. Chassi s i ntrusi on connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component

is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper cap only when you intend to use the chassis intrusion detection feature.

+5VSB MB	Chassis Signal GND
CHASSIS	(Default)
Chassis Intrusion Connector

11. Seri al port connector (10-1 pi n COM2)

This connector is for a serial (COM) port. Connect the serial port module cable to this connector, then install the module to a slot opening at the back of the system chassis.

COM2

PIN 1

COM Port Connector

ASUS Vintage V2-PE2 4-11