Getting Started
Telephone base & charger installation
Install the base and charger as shown below. Choose a base location away from electronic equipment, such as personal computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.
Getting Started
Battery installation & charging
After installation, place the handset in the base or charger and allow to charge for 12 hours before use. You can keep batteries charged by placing the handset in the base or charger after each use. When batteries are fully depleted, a recharge takes about 10 hours.
LOW BATTERY
NOTE: Use only the power cord supplied with this product.
If you need a replacement, call
Be sure to use an electrical outlet not controlled by a wall switch.
Plug base power cord transformer into electrical outlet
Plug long telephone line cord into telephone jack
Press coin into slot on base of handset to release latch, then remove cover
Low battery indicator
Return handset to base or charger when this symbol flashes. (Handset will beep when battery is low.)
Insert supplied batteries
Caution: Use only supplied rechargeable battery or AT&T replacement battery model 2419 / 2420 (sku 00578).
Plug charger power cord into jack on underside of charger, then plug transformer into electrical outlet
Insert top tabs first
Place handset in base or charger to charge for 12 hours before first use.
Press down to click in place
6 | 7 |
