AT&T 6750G Configure the Notebook adapter for your wireless network, Wizard screen, Ssid

Adapter Configuration

Wizard • Link Info. • Configuration • Security • Site Survey • About

STEP 4: Configure the Notebook adapter for your wireless network

Check the Utility icon (four vertical bars) next to your computer’s time display. If the bars are green, you are already connected and do not need to run the Wizard (skip to bottom of page 6). If the bars are not green within 30 seconds, double-click the Utility icon, then click the Run Wizard button at the next screen.

Double-click here to launch Utility (see below). Number of green bars shows signal strength.

Click to begin.

Wizard screen 1

SSID

Enter the SSID (Service Set Identifier) used by your wireless router or access point. The default SSID is at&t. The SSID is case sensi- tive (i.e., “cat” and “Cat” are not the same). All wireless adapters on your network must use the same SSID as your wireless router and/or access point.

WEP Encryption

WEP is a form of encryption. If you click On to enable encryption in your wireless adapter, you must turn on WEP in your router, and make sure all devices use the same settings.

Click Apply to save your settings and display Wizard screen 2 (see next page).

NOTE: The Wizard screen (above) always shows factory default settings, even if you have changed them. Go to the Configuration screen to see your customized settings.

CAUTION: SSID and all WEP settings must be identical in all wireless network devices. WEP Ascii/Hex Key must match the WEP settings used in your router (may be called Security Phrase, Hex Key or other term).

AT&T Plug&Share™ Wireless Notebook Adapter 108 Mbps 6750G 5