AT&T 929 user manual Installation

Installation

3.Set the tone/pulse switch. If you have touch tone service, set the switch to TT (tone). If you have dial pulse (rotary) service, set the switch to DP (pulse).

4.Connect the telephone line cord to the telephone. Plug the telephone line cord into the jack labeled LINE IN and route it into the groove on the telephone base as shown below. If you subscribe to high-speed internet service (Digital Subscriber Line - DSL) through your telephone line, you must have a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.

Telephone wall jack

DSL filter (not included) required if you have DSL

high-speed internet service.

Telephone line cord