Getting started
Battery installation and charging
Install the battery as shown on page 7. Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 10 hours of continuous charging. See the table on page 28 for battery operating times.
If the screen shows Place in charger and 
flashes, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. The following table summarizes the battery charge indicators and actions to take.
Battery indicators | Battery status | Action |
|
|
|
The screen is blank, | Battery has no or | Charge without interruption until |
or shows Place in | very little charge. The | the screen shows Low battery |
charger and | handset cannot be used. | or HANDSET X (at least 30 |
(flashing). |
| minutes). |
|
|
|
The screen shows | Battery has enough | Charge without interruption until |
Low battery and | charge to be used for a | the screen shows HANDSET X (at |
(flashing). | short time. | least 30 minutes). |
|
|
|
The screen shows | Battery is charged. | To keep the battery charged, |
HANDSET X. |
| place it in the telephone base or |
|
| charger when not in use. |
|
|
|
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute.
