To Remove Existing Thermostat
ELECTRICAL SHOCK HAZARD – Turn off power at the main service panel by removing the fuse or switching the appropriate circuit breaker to the OFF position before removing the existing thermostat.
1.Turn off power to the heating and cooling system by removing the fuse or switching the appropriate circuit breaker off.
2.Remove cover of old thermostat. This should expose the wires.
3.Label the existing wires with the enclosed wire labels before removing wires.
4.After labeling wires, remove wires from wire terminals.
5.Remove existing thermostat base from wall.
6.Refer to the following section for instructions on how to install this thermostat.
To Install Thermostat
ELECTRICAL SHOCK HAZARD – Turn off power at the main service panel by removing the fuse or switching the appropriate circuit breaker to the OFF position before removing the existing thermostat.
IMPORTANT: Thermostat installation must conform to local and national building and electrical codes and ordinances.
Note: Mount the thermostat about five feet above the floor. Do not mount the thermostat on an outside wall, in direct sunlight, behind a door, or in an area affected by a vent or duct.
1.Turn off power to the heating and cooling system by removing the fuse or switching the appropriate circuit breaker off.
3
