Telephone base & charger installation
Install the telephone as shown below.
The telephone base is ready for tabletop use. If you want to change to wall mounting, see user’s manual for details.
1.Plug one end of the telephone line cord into the telephone jack on the bottom of the telephone base.
7.Raise the antenna.
2. Route the power adapter cord through the slot.
3. Plug the small end of the telephone base power adapter into the power jack on the bottom of the telephone base.
4. Place the cords into the channels.
Telephone line cord
Power
adapter
6. Plug the other end | If you have DSL high | |
of the telephone | speed Internet | |
line cord into a | service, a DSL filter | |
telephone jack or a | (not included) is | |
required. | ||
DSL filter. | ||
|
Charger installation
IMPORTANT INFORMATION
5.Plug the large end of 
the power adapter
into a power outlet
not controlled by a wall switch.
Plug the power adapter into an electrical outlet not controlled by a wall switch.
1.Use only the power adapter(s) supplied with this product. To order a replacement power adapter, visit our website at www.telephones.att.com, or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
2.The power adapters are intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-
2
