1.
CLOCK
The system will announce the current clock setting, then announces "To set the clock, press CLOCK."
2.
CLOCK
The system will announce the current day setting, then announces "To change the day, press SKIP or REPEAT, to change the hour, press CLOCK."
3.
SKIP or 
REPEAT
until the system announces the correct day, then press
CLOCK.
4.
SKIP or 
REPEAT
until the system announces the correct hour, then press
CLOCK.
5.
SKIP or 
REPEAT
until the system announces the correct minutes, then press CLOCK.
6.
SKIP or 
REPEAT
until the system announces the correct year, then press CLOCK. The system announces the current clock setting.
Answering system operation
Day and time announcements
To set day and time
Before playing each message, the answering system announces the day and time when the message was received.
Before using the answering system, follow the steps to the left of this page to set the day, time and year, so that messages are dated correctly. If the clock is not set, before new messages are recorded, the system will announce "Time and day not set" before each message is played back.
The system uses voice prompts to guide you. Each time you press 
SKIP or 
REPEAT, the day, hour, minute or year increases or decreases by one. When you hear the correct setting, press CLOCK to move to the next setting.
To check day and time
You can press CLOCK at any time to hear the cur- rent day and time without changing it.
NOTES:
1.You can press and hold 
SKIP or 
REPEAT to increase or decrease the minutes or years by increments of ten.
2.Caller ID provides the time and date. Set the year so that the day of the week can be calculated from the caller ID information. After you set the time once, it will thereafter be set automatically with incoming caller ID information. The time will be set automatically only if you subscribe to caller ID service provided by your local telephone com- pany (page 30).
35
