Appendix

Troubleshooting

My cordless handset beeps five times and isn’t performing normally.

Make sure the power cord is securely plugged into the base. Plug the unit into a different, working electrical outlet not controlled by a wall switch.

Move the cordless handset closer to the base. You might have moved out of range.

Reset the base. Unplug the unit’s electrical power. Wait for 15 sec- onds then plug it back in. Allow up to one minute for the cordless handset and base to reset.

Other electronic products can cause interference to your cordless phone. Try installing your phone as far away from these types of electronic devices as possible: wireless routers, radios, radio towers, pager towers, cell phones, intercoms, room monitors, televisions, personal computers, kitchen appliances and other cordless phones.

OTHER HANDSET ON (and then) OR OUT OF RANGE displays on my cordless hand- set.

Only one handset can be used to make or answer a call anytime. If another handset attempt to do so, the screen will display OTHER HANDSET ON and then OR OUT OF RANGE. You might press PHONE or SPEAKER again until no other handset is using the line. Use the call transfer feature (see page 15) to transfer a call to another system hand- set or use the speakerphone feature so multiple members of your house can be on an active call at the same time.

Move the cordless handset closer to the base. You might have moved out of range.

Ensure that the base is powered up.

Place the cordless handset in base cradle for 1 minute to allow the cordless handset and base to resynchronize channels.

If the cordless handset is in its base and the charging light does not come on, refer to the charge light is off in this troubleshooting guide.

Reset the base. Unplug the unit’s electrical power. Wait for 15 seconds then plug it back in. Allow up to one minute for the cordless handset and base to reset.

Other electronic products can cause interference with your cordless phone. Try installing your phone as far away from these types of elec tronic devices as possible: wireless routers, radios, radio towers, page towers, cell phones, intercoms, room monitors, televisions, personal computers, kitchen appliances and cordless phones.

The batteries will not hold a charge.

Charge the battery in the cordless handset for at least 16 hours. For optimum daily performance, return the cordless handset to its base when not in use.

Ensure that the battery is properly installed and charged as described on page 7.

Ensure that the telephone base and charger units are plugged into functioning power outlets.

If your battery is old, you may need to purchase a new battery pack, see page 7.

Your phone might be malfunctioning. Please refer to the Warranty section of this user’s manual for further instruction.

If the cordless handset is in its base and the charging light does not come on, refer to “The charge light is off” in this troubleshooting guide.

31

Page 35
Image 35
AT&T E2717B user manual Batteries will not hold a charge