Battery & charger installation
After installation, place the handset in the handset charger or the telephone base and allow the battery to charge for at least 16 hours before use. You can keep the battery charged by returning the handset to the handset charger or the telephone base after each use. When battery power is completely depleted, a full recharge takes about 16 hours. The average talk time on a completely charged battery is about eight hours depending on the environmental conditions, and the standby time is approximately four days.
LOW BATTERY
Low battery indicator
Return handset to the handset charger or the telephone base to recharge when this symbol flashes. (The handset will beep when battery is low.)
Align the two holes in the connector with the socket pins according to the diagram inside the battery compartment, then snap the connector into place.
Press tab and slide the |
|
| |
cover away from the center | Place the battery | Replace the compartment | |
of the telephone to open | and wires in the | cover by sliding it towards | |
battery compartment. | the center of the handset | ||
compartment. | |||
Caution: Use only the supplied | until it is securely in place. | ||
| |||
|
|
rechargeable battery or AT&T replacement battery model
27910 (SKU 00102. Part number
89-0099-00-00).
Plug the power cord into the jack on the underside of the handset charger, then plug the power adapter into an electrical outlet not controlled by a wall switch.
NOTE: Use only the power adapter
supplied with this product. If you need |
|
a replacement, call 1 (800) | CHARGER light remains |
Be sure to use an electrical outlet not | |
controlled by a wall switch. | on while battery is charging. |
|
3
