AT&T E5811 user manual Charge

ɇŽŽƒŒ‚‡–

Troubleshooting

The CHARGE	ƨ ŠƒŒ’†ƒ‹ƒ’ŠŠ‡† ‡Œ Œ’’‘Œ’†ƒ‚Šƒ‘‘†Œ‚-
light is off	set and telephone base each month using a pencil eraser
	or a dry non-abrasive fabric.
	ƨ ‰ƒ‘“ƒ’†ƒŽ•ƒ‚Ž’ƒŒ‚’ƒŠƒŽ†ŒƒŠ‡Œƒ‚‘ƒ
	plugged in correctly and securely.
	ƨ ŒŽŠ“  ’†ƒ Ž•ƒ ‚Ž’ƒƓ ‡’ „ ǍǑ ‘ƒŒ‚‘ €ƒ„ƒ
	plugging it back in. Allow up to one minute for the cordless
	handset and telephone base to reset.
	ƨ †ƒ’ƒŠƒŽ†Œƒ‹‡ †’€ƒ‹Š„“Œ’‡Œ‡Œ ƓŠƒ‘ƒƒ„ƒ’
	the Limited warranty section of this user’s manual for
	further instruction.
There is no dial ƨ ‡‘’Ɛ’—ŠŠ’†ƒ€”ƒ‘“ ƒ‘’‡Œ‘Ɠ
tone	ƨ ”ƒ’†ƒ‚Šƒ‘‘†Œ‚‘ƒ’Š‘ƒ’’†ƒ’ƒŠƒŽ†Œƒ€‘ƒƓ
	It might be out of range.
	ƨ †ƒ ’ƒŠƒŽ†Œƒ Š‡Œƒ ‚ ‹‡ †’ €ƒ ‹Š„“Œ’‡Œ‡Œ Ɠ —
	installing a new telephone line cord.
	ƨ ‡‘ŒŒƒ’ ’†ƒ ’ƒŠƒŽ†Œƒ €‘ƒ „‹ ’†ƒ ’ƒŠƒŽ†Œƒ ˆ‰
	and connect a different telephone. If there is no dial tone
	on the telephone either, the problem is in your wiring or
	local service. Contact your local telephone company.
The telephone	ƨ ‰ƒ‘“ƒ’†ƒ‡Œ ƒ‡‘ŒƪŽ ƒ‘ǍǍƕǍǎƫƓ
does not ring	ƨ ‰ƒ ‘“ƒ ’†ƒ ’ƒŠƒŽ†Œƒ Š‡Œƒ ‚ Œ‚ Ž•ƒ ‚Ž’ƒ
when there is	are plugged in properly (page 6).
an incoming	ƨ †ƒ‚Šƒ‘‘†Œ‚‘ƒ’‹—€ƒ’„„‹’†ƒ’ƒŠƒŽ†Œƒ

call	base. Move it closer to the telephone base.
	ƨ †ƒƒ‹—€ƒ’‹Œ—ƒ–’ƒŒ‘‡Œ’ƒŠƒŽ†Œƒ‘Œ’†ƒ’ƒŠ-
	ephone line to allow all of them to ring simultaneously.
	Try unplugging some of them.
	ƨ „’†ƒ’†ƒ’ƒŠƒŽ†Œƒ‘‡Œ—“†‹ƒƒ†”‡Œ ’†ƒ‘‹ƒ
	problem, the problem is in the wiring or local service.
	Contact the local telephone company (charges may apply).
	ƨ ’†ƒƒŠƒ’Œ‡Ž‚“’‘Œ“‘ƒ‡Œ’ƒ„ƒƒŒƒ’—“
	cordless telephone. Try installing your telephone as far
	away as possible from the following electronic devices:
	wireless routers, radios, radio towers, pager towers, cel-
	lular telephones, digital telephones, intercoms, room
	‹Œ‡’‘Ɛ’ƒŠƒ”‡‘‡Œ‘Ɛ‘ƐŽƒ‘ŒŠ‹Ž“’ƒ‘Ɛ‰‡’†ƒŒ
	appliances, and other cordless telephones.

41