
Appendix C
Troubleshooting
The answering system does not respond to remote commands.
•Make sure your remote access code is correct (page 38).
•Make sure you are calling from a
•The answering system may not detect the remote access code when your announcement is playing. Wait until the announcement is over before entering the code.
•There may be interference on the telephone line you are using. Press the dial pad keys firmly when dialing.
Common cure | • If the telephone is not responding normally, try putting | |
for electronic | the cordless handset in the telephone base. If it does | |
equipment. | not seem to respond, try the following (in the order | |
| listed): | |
| 1. | Disconnect the power to the telephone base. |
| 2. | Disconnect the battery on the cordless handset. |
| 3. | Wait a few minutes before connecting power to the |
|
| telephone base. |
| 4. | |
|
| into the telephone base . |
| 5. | Wait for the cordless handset to synchronize its |
|
| connection with the telephone base. Allow up to one |
|
| minute for this to take place. |
48