4

Getting started

If you subscribe to high-speed Internet service (DSL - digital subscriber line)

through your telephone line, you must install a DSL filter between the

telephone line cord and the telephone wall jack. The filter prevents noise and

caller ID problems caused by DSL interference. Please contact your DSL service

provider for more information about DSL filters.

The telephone base comes ready for tabletop use. If you want to mount your

telephone on a wall, refer to Wall mount installation on page 7 for details.

Telephone base installation
Telephone line cord
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
Telephone wall jack
Plug one end of the
telephone line cord
into the TEL. LINE
jack on the bottom of
the telephone base.
Plug the other end
of the telephone
line cord into a
telephone wall jack.
Plug the small end
of the power adapter
into the power jack
on the bottom of the
telephone base.
Electrical outlet not
controlled by a wall
switch
Plug the large end
of the power adapter
into an electrical
outlet not controlled
by a wall switch.
Route the cords
through the slots.
IMPORTANT INFORMATION:
Use only the power adapter provided with this product. To obtain a replacement, visit our
website at www.telephones.att.com or call 1 (800) 222-3111. In Canada,
dial 1 (866) 288-4268.