AT&T TL7610, TL7611 Adding and registering headset to telephone

Registration and de-registration

Adding and registering headset to telephone

To register the headset to an AT&T DECT cordless telephone

base:

You must de-register the headset from the

headset base (see page 34).

Make sure the battery is properly installed

in the headset (see page 12). The ON/OFF

light flashes twice every five seconds to

indicate the headset is not registered.

Place the headset in the headset base and

allow it to charge for at least five minutes

before beginning registration. Leave the

headset in the base while registering the

headset.

On the telephone base of the cordless

phone, press and hold the HANDSET

LOCATOR button until the IN USE light

comes on (about four seconds) and release

the button.

The headset is registered to the telephone

base automatically; this may take about 30

seconds to complete. The IN USE light on

the telephone base turns off. The headset

ON/OFF light turns blue on the first headset

registered. The headset ON/OFF light turns

orange on the second headset registered. To

verify registration was successful, press the

headset ON/OFF button and check for a dial

tone.

NOTE: If the registration is not successful, the ON/OFF light on the headset

flashes twice every five seconds. Reset the headset and try again. Remove the

headset from the base and press ON/OFF. Then place the headset back into the

headset base. Try the registration process again.