2.Plug the cable from the ADC display into the Console port connector of the Master View
3.Use the ADC cables provided with this package to connect the
Note: If your computer uses a DVI type connector, you will
have to use an ADC to DVI adapter (requires separate purchase). Refer back to the Note in the Cables Section on p. 3, for details.
4.Turn On the power to the computers.
5.Turn On the ADC Display.
Powering On Considerations:
1.When you Power On, the Display and the computers take a few moments to establish their communication parameters.
You must wait until the procedure completes (i.e., the desktop finishes coming up and is ready to accept computer input) before changing ports. Otherwise, when you switch back to the original port, the display will either be blank or distorted.
If this occurs, you must Power Off the system (see p. 10), and Power it back On (see steps 4 and 5, above).
2.The Power On default is to link to ADC Port 1. If the computer attached to port 1 is inactive, the display will be blank so it may appear as if the unit is not functioning. This is not the case. Simply press the Port Selection switch to toggle the KVM focus to the active computer on port 2.
- 7 -
