| 4. OSD Operation | |
|
|
|
|
|
|
|
| |
Setting | Function | |
|
| |
SET ACCESSIBLE | This function allows Administrators and Users to select which | |
PORTS | Ports can be accessed from a particular Console. Move the | |
| highlight bar to the target computer, then press [Enter] or the | |
| [Spacebar] to toggle access On and Off. If access is On, a | |
| plus mark ( + ) appears to indicate so. If access is Off, the | |
| area is blank. Make your choice, then press [Esc] to confirm. | |
|
| |
SET MULTIUSER | This function determines whether or not the same ID can be | |
MODE | used to log into the CS428 from different Consoles at the | |
| same time. | |
| 1. If Disabled, the same ID cannot be used; if Enabled (the | |
| default), the same ID can be used to log in from more than | |
| one Console. | |
| 2. If Enabled, the F4, F6, and F7 settings set for any one | |
| Console, will be the same for all other Consoles that log in | |
| with the same ID. | |
| 3. Changes made to the F4, F6, and F7 settings by any | |
| logged in Console will automatically affect all Consoles | |
| with the same ID. | |
|
| |
SET ACCESS | This function is used to set the timeout value to control the | |
TIMEOUT | release of access rights to a computer. If the original Console | |
| doesn't access the computer before the timeout value is | |
| reached, the computer becomes available to the other | |
| Consoles. To set the timeout value, key in a number from 2 - | |
| 255 seconds, then press [Enter] (if the number is 0 [zero], | |
| this function is disabled. Default is 010 (ten) seconds. | |
|
| |
CLEAR THE NAME | This function is used to undo all Administrator changes and | |
LIST | return the setup to the original factory default settings. | |
| Note: While this function is in progress, make sure that no | |
| other operations are performed on any of the other Consoles. | |
|
| |
RESTORE DEFAULT | This function is used to undo all Administrator changes and | |
VALUES | return the setup to the original factory default settings - except | |
| for the Names that were assigned to Ports, which are saved. | |
|
| |
RELEASE ALL | Releases all Ports that have been set to Private Mode (see | |
PRIVATE | PRIVATE MODE, page 23), so that they become accessible | |
| to all Consoles. | |
|
| |
SET LOGOUT | If a Console that has accessed a computer isn't used for the | |
TIMEOUT | amount of time set with this function, the Operator is | |
| automatically logged out. A login is necessary before the | |
| Console can be used again. This enables the other Consoles | |
| to gain access to the computers when the original Console is | |
| no longer accessing them, but the Operator has forgotten to | |
| relinquish access. To set the timeout value, key in a number | |
| from 1 - 255 minutes, then press [Enter] If the number is 0 | |
| [zero], this function is disabled. Default is 5 (five) minutes. | |
21