1. Introduction

 

 

 

 

 

 

 

 

 

No.

Component

Description

 

 

 

1

Port Selection

Š Press a switch to give the KVM focus to the computer

 

Switches

attached to its corresponding port.

 

 

Š Simultaneously pressing Buttons 1 and 2 for 3 seconds

 

 

performs a Keyboard and Mouse Reset.

 

 

Š Simultaneously pressing Buttons 3 and 4 on the

 

 

CS-9134 starts Auto Scan Mode.

 

 

Š Simultaneously pressing Buttons 7 and 8 on the

 

 

CS-9138 starts Auto Scan Mode.

 

 

 

2

Port LEDs

The Port LEDs are built into the Port Selection Switches.

 

 

The upper ones are the On Line LEDs; the lower ones are

 

 

the Selected Port LEDs:

 

 

Š An On Line LED lights GREEN to indicate that the

 

 

computer attached to its corresponding port is up and

 

 

running. A flashing LED indicates that the Port is being

 

 

used for cascading to another switch.

 

 

Š A Selected LED lights ORANGE to indicate that the

 

 

computer attached to its corresponding port is the one

 

 

that has the KVM focus. The LED is steady under

 

 

normal conditions, but flashes when its port is accessed

 

 

under Auto Scan Mode.

 

 

 

3

Sound Opening

System sounds (beeps, etc.) are emitted from this

 

 

opening.

 

 

 

4

Reset

Use a thin object (such as the end of a paper clip, or a

 

 

ballpoint pen), to press this recessed switch in to initiate a

 

 

warm reset. If the switch is kept in for longer than three

 

 

seconds, a cold reset takes place.

 

 

 

5

Power LED

Lights to indicate that the unit is receiving power.

 

 

 

5