SN0108 / SN0116 User Manual
3.Select either Obtain an IP address automatically (DHCP), or Specify an IP address. If you chose the latter, fill the IP Address, Subnet Mask, and Gateway fields with the information appropriate to your network.
4.Click Set IP.
5.After the IP address shows up in the Device List, click Exit to end the program.
Method 2:
1.Set your computer's IP address to 192.168.0.XXX
Where XXX represents any number or numbers except 60. (192.168.0.60 is the default address of the SN0108 / SN0116.)
2.Specify the switch's default IP address (192.168.0.60) in your browser, and you will be able to connect.
3.Assign a fixed IP address for the SN0108 / SN0116 that is suitable for the network segment that it resides on.
4.After you log out, reset your computer's IP address to its original value.
Method 3:
A fixed IP address can also be assigned with the ARP command as follows:
1.Turn off the power to the SN0108 / SN0116.
2.Enter the following command:
arp
Where the IP address that you assign is one suitable for the network segment that the SN0108 / SN0116 resides on.
Note: The MAC address can be found on the bottom panel.
3.Turn the power to the SN0108 / SN0116 back on.
4.In your browser, go to the IP address you just assigned and log in with your Username and Password.
Note: You must log in within 30 seconds after entering the arp command. Therefore, it would be advisable to have your browser all set up to go to the IP address beforehand.
5.Once you have logged in, go to Network, to set up the permanent IP environment (see page 23).
94