Installation
1.Make sure that the power to any device that you connect to the installation has been turned off.
2.Make sure that all devices you will be installing are properly grounded.
Installation of the VM0404H is simply a matter of plugging in the appropriate cables. To install the switch, refer to the installation diagram below as you perform the following steps:
1.Use HDMI cables to connect the HDMI In ports on the video display devices to the HDMI Out ports on the rear panel of the VM0404H.
2.Use HDMI cables to connect the HDMI Out ports on the source device(s) to the HDMI In ports on the VM0404H. Four HDMI In ports are located on the rear panel of the switch.
3.Plug the provided power adapter into an appropriate AC power source; plug the power adapter cable into the Power Jack on the VM0404H.
4.(Optional) If you are using the serial control function (see page 11), use an appropriate
5.You may now power on the display and source devices.
HDMI Source Devices
2
4
Hardware / Software
Controller
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
HDMI OUT | HDMI OUT | HDMI OUT | HDMI OUT | HDMI IN | HDMI IN | HDMI IN | HDMI IN | ||||||||||
3
1
HDMI Display Devices
- 10 -